Topcon HiPER GD, Operator'S Manual

Page: 61 / 180

MINTER Configuration
1-866-4TOPCON www.topconpositioning.com
2-19
NOTICE
Disconnecting the receiver from the computer
before exiting will eliminate any possible conflict
in the management of your serial ports.
Once the receiver is configured, the configuration will remain until
you change it either using PC-CDU or clearing the NVRAM.
MINTER Configuration
The Minimum INTERface (MINTER) consists of two keys (Power
and FN) and up to four LEDs (STAT, REC, BATT, and RX) that
control and display the receiver’s operation (Figure 2-19 on
page 2-20).
The MINTER allows performs numerous functions:
• Turn the receiver on/off, put it in Sleep or Zero power mode.
• Turn data recording on or off (FN key).
• Change the receiver’s information mode.
• Show the number of GPS (green) and GLONASS (orange)
satellites being tracked (STAT LED).
• Show data recording status (REC LED).
• Show each time data records to internal memory (REC LED).
• Show the status of post-processing mode (static or dynamic)
when performing a Post-Processing Kinematic survey with the
help of FN key (REC LED).
• Show the status (high charge, intermediate charge, or low
charge) of the battery (BATT LED).
• Show the power source for the receiver (BATT LED).
• Show the modem’s status and if it receives signals (RX LED).