14/03/2017
Vers. 1.0
57
WARNING!
If the internal cleaning is interrupted it will be requie every time, even selecting the same system type.
Select “Start” to run automatically the whole cycle.
The standars can be modify “temporarily” and it’s possible to perform the various functions separately (Recovery
(R), Vacuum (V), Vacuum Test (T), Oil Injection (standard/hybrid), Gas Charge (C)) following the instructions
contained in section "Manual/Automatic".
10.5.1 Personal DataBase
Parameters Storing
The personal database can contain up to 100 positions.
To store the data you have to enter in the menue DataBase and choose the category PersonalDB.
Select the position on where you want to store the data.
It will appear the following screen:
Set the parameters of the functions Vacuum (minutes), Vacuum Test (minutes), Oil Charge (grams), Gas Charge
(grams).
Press “C” button to store the data set.
Use of the stored data
At first select the desired refrigerant (R134 or HFO1234YF) from the page Home.
ATTENTION !
Before selecting the system type make sure that the two HP and LP rapid couplings present at the
end of the hoses are connected to the two male couplings present on the station!
To use the stored data you have to enter in the menu DataBase and choose the category Personal DB.
Select the position where the data have been yet stored.
It will appear the following screen with the previous stored data:
Press “Enter” to pass on the screen Manual/Automatic, from which you can start the automatic cycle or the single
functions in manual.
10.6 Printing (only Printer version)
10.6.1 Individual printing
The printing function provides the printing of the last operation executed.
Image 32
– Personal DataBase
Image 33
– Personal DataBase
