ToolPRO 2200W, Instruction Manual

Page: 18 / 24

18 19
CLEANING THE FUEL VALVE FILTER
The fuel valve filter prevents dirt and water that may have
gotten into the fuel tank from entering the carburetor. If
the engine has not been run for a long time, the fuel valve
filter should be cleaned before use.
1. Turn the fuel valve to the OFF position.
2. Unscrew the 4 bolts on fuel tank, use pliers to loosen
the tubing clamp and unplug it. (Pic. 19 & 20).
3. Remove fuel valve from fuel tank.
4. Remove filter from fuel valve (Pic. 21).
5. Clean the filter.
6. Check the washer, replace if broken.
7. Assemble everything back together after inspection
and return the fuel valve to ON position and check for
leaks.
CLEANING THE EXHAUST PORT & MUFFLER
Depending on the type of fuel used, the type and amount
of oil used, and/or your operating conditions, the exhaust
port and muffler may become blocked with carbon
deposits. If you notice a power loss with your petrol-
powered tool, you may need to remove these deposits
to restore performance. We highly recommend that only
qualified service technicians perform this service.
CLEANING THE FUEL TANK FILTER
1. Remove fuel cap and filter.
2. Clean the filter, replace if broken.
3. Dry the filter and install back on the generator.
DRAINING THE FUEL TANK
1. Turn the engine switch OFF ( O ).
2. Close fuel valve.
3. Remove the fuel line from the barb by using pliers to
loosen the tubing clamp and sliding the fuel line off
(Pic. 19 & 20).
4. Install one end of a drain line over the barb, and place
the other end in a fuel container large enough to catch
the fuel being drained from the tank.
5. Open fuel valve.
6. When the fuel has drained from the tank, close the
fuel valve and reinstall fuel line on barb.
PIC. 19
PIC. 21
PIC. 20