ToolPRO 2200W, Instruction Manual

Page: 10 / 24

10 11
OPERATING INSTRUCTIONS
UNPACKING
Carefully unpack your generator. This generator is heavy
(12.8kg) and may require two (2) people to lift. Dispose
of all packing material in an environmentally responsible
manner.
Open carton, gently lift the generator clear of the carton
and packaging, this may require 2 people. Remove from
plastic bag.
NOTE: Plastic bags can be a danger to young children,
dispose of immediately. Always dispose of packaging in
a responsible manner.
ASSEMBLY
This generator requires no assembly, however the motor
requires oil, SAE 30W or SAE 15W-40, to be added to
the sump before you can use, refer to page 8 for specific
details.
ADDING LUBRICATING OIL
Always use clean fresh oil as specified on page 8.
Incorrect or old oil can cause the generator to run rough
and damage the motor; this will not be covered by
warranty.
1. Ensure that engine is OFF when filling oil.
2. Use oil as detailed on page 8, SAE 30W
or SAE 15W-40 4-stroke motor oil.
3. Ensure generator is level when filling with oil.
DO NOT TIP - USE A FUNNEL (NOT SUPPLIED)
4. Remove oil filler cap, Pic. 2.
5. Only fill oil to the top of the thread, Pic. 3.
6. Ensure that the oil filler cap is screwed on tightly
before attempting to start the generator.
WARNING! Over filling the oil can damage the generator,
this damage will not be covered under warranty.
NOTE:
Check oil daily and especially before use.
FILLING THE FUEL TANK
UNLEADED 91 PETROL - NO ETHANOL
Always use clean fresh fuel as specified on page 8. Stale
fuel can cause the generator to run rough and damage
the motor; this will not be covered by warranty.
1. Ensure the engine is OFF.
2. Ensure the fuel/engine switch is OFF.
3. Use fresh fuel as detailed on page 8, unleaded petrol.
4. Do not fill fuel tank above the fuel filter, Pic. 4.
5. Ensure that the fuel tank cap is screwed on tightly.
To drain fuel refer to page 18.
PIC. 3
PIC. 4
Oil Filler Cap
PIC. 2