ToolPRO 2200W, Instruction Manual

Page: 11 / 24

10 11
GENERATOR ‘EARTHING’
Always ensure that this generator is “Earthed” BEFORE
starting and using.
1. Ensure that engine is OFF when fitting the “Earth”
stake and wire.
2. Attach the wire to the “Earth” point on the generator,
see Pic. 5.
3. Push the attached stake into the ground. Ensure that
this is not a trip hazard when near the generator.
4. Ensure the generator is OFF and cool before removing
the “Earth” stake and wire.
STARTING YOUR GENERATOR
Warning! Never start your generator without “earth” stake
attached or with electrical appliances or power leads
attached.
1. Ensure the ”Earth” stake and wire are attached, Pic. 5.
2. Turn the fuel tap ON, Pic. 6.
3. Turn choke to CLOSED / START by sliding the choke
lever to the left, Pic. 7.
4. Turn the engine switch to ON, Pic. 8.
5. Hold down the generator firmly with one hand on the
frame, then pull the recoil starter slowly until engaged,
then pull briskly, Pic. 9. This step may need to be
repeated until generator engine starts, this can take
up to about 12 pulls.
Warning! Never pull the recoil once the engine has
started. Any damage caused will not be covered under
warranty.
6. Allow engine to run up to speed, this usually takes up
to about 5-10 seconds.
O
FF
ON
CHOKE
OPEN CLOSED
PIC. 7
PIC. 8
PIC. 9 PIC. 5
PIC. 6
START
RUN
ON
OFF
Earth Point