Tool Shop 241-8501, Owner'S Manual

Page: 12 / 23

12
INSTALLING ACCESSORIES
All accessories are installed on the multi-
function power tool in a similar manner.
For the purposes of describing the
accessory installation, the half circle blade
is used.
DANGER:
Always remove the plug
from the power source before installing
or removing accessories or sandpaper.
Failing to remove the plug from the
power source may result in the tool
accidentally being started and causing
serious injury to the operator.
1. Remove the screw (1) and large
washer (2) from the accessory holder
(3) by turning the screw counter
clockwise. Use the 5 mm Hex key (4)
if the screw is too tight to be removed
by hand (Fig. 1).
2. Place the blade (5) on the accessory
holder (Fig. 2).
NOTES:
a) Make sure the alignment holes (6) in
the blade fit over the alignment pins
(7) in the accessory holder and the
printed side of the blade is facing the
tool.
b) The blade can be mounted at various
angles left or right of center if
required.
3. Thread the screw (1) through the large
washer (2) and the blade and into the
accessory holder threaded hole (8).
4. Turn the screw clockwise until it is
finger tight.
ASSEMBLY AND OPERATING
!
ASSEMBLY AND OPERATING ASSEMBLY AND OPERATING
Fig. 1
Fig. 2