Tool Shop 241-8501, Owner'S Manual

Page: 18 / 23

18
USING THE DETAIL SANDER ATTACHMENT
– cont’d
This tool is designed for detail sanding on
small surface areas. Place the sandpaper
surface of the sanding pad on the
workpiece to be sanded. Keep the tool
moving to avoid gouging the surface. Use
coarse sandpaper and lower speeds when
sanding rough surfaces and for removing
previous finishes. Use fine sandpaper and
higher speeds to produce the smoothest
surface.
USING THE SCRAPER BLADE
1. Install the scraper blade on the multi-
function power tool as outlined on
Pages 12 & 13, Fig. 2.
2. Turn the switch ON.
When using the scraper blade to scrape
old finishes or glue from a workpiece,
place the under side of the blade flat on
the workpiece surface and then lift upward
on the rear of the tool to allow the blade to
form a very slight angle with the workpiece
surface. Feed the blade slowly into the
material that is to be removed. Do not
force the tool as slower travel speeds will
produce better cutting action and reduce
the risk of gouging the workpiece.
When using the scraper blade to cut
carpet, place a scrap workpiece under the
carpet where the cut is being made. Turn
the tool so the scraper blade is at right
angles (perpendicular) to the carpet and
then feed the blade into the carpet.
ASSEMBLY AND OPERATING