37
DVR
4.2 Power on Wizard
After device boot, you can do simple configuration through power on wizard to make DVR working normal and the interface as below:
Setting method: access “System Setup” -> “General”, then choose the “Display power on wizard” and save, next time boot will prompt whether access power on wizard.
Note: please confirm the HDD has connected with SATA port before use initial start wizard.
The simple configuration in power on wizard as below:
1. Ensure whether access the power on wizard, choose “Yes” to access.
2. Authority filter, input the password (the default is 888888).
3. System time setting, click save after set finish and choose “Next”.
4. Network setting, you can set the IP, gateway, DNS, command port, HTTP port; click “Save” after set finish and choose “Next”.
5. HDD management, choose the HDD number which you want format then click “Format”, after pop-up “Are you sure to format HDD?”, click “Yes” to format the HDD, after finish
choose “Next”.
Note: if you choose “Format log” and choose the 1st HDD in list when format HDD, then the log can be formatted, otherwise the log can’t be formatted.
6. Coding parameter, click “Save” after set the local stream and network stream, if other channels have same setting, choose “Copy” to access, then choose which channel need copy,
click “Save” then choose “Next”.
7. Record setting, choose the channel which you want enable manual record, click “Save” then choose “Finish” to exit power start wizard.
