Tomey TCP-2000, User Manual

Page: 19 / 50

Operation Manual
19
you selected. Device will signal with 2 beep signal each time you enter user’s
program.
In the left bottom corner of the screen a letter ‘A’ is displayed to inform that user
program mode is executed.
Use right Arrow to move to the next chart of the program, left Arrow to return to
the previous chart. Each program is executed in loops, meaning that each time you
reach last chart of the program, pressing right Arrow will start sequence from the
first step. Pressing left Arrow when the first chart of the program is displayed will
result in jumping to the last step of the program.
To switch to other program or to restart selected program press respectively ‘
F1 ’,
‘ F2 ’ or ‘ F3 ’ button.
To enter normal operating mode press any other button than ‘
F1 ’, ‘ F2 ’, ‘ F3 ’ or
Left and Right Arrow.
4.13. Auto-Off
This function allows user to preset time after which Chart Panel enters stand-by
mode. You can set this time from 4 to 10 minutes.
1.
Enter ‘ Auto-Off ’ using Arrow Up or Arrow Down button.
2. Press Right Arrow to edit time for automatic power off.
3. Use Up and Down Arrow to set required time.
4. To store selected value press Left Arrow.
15 seconds before automatic turn off TCP-2000 will give user two notification
signals (beeps). If TCP-2000 is in Auto–Off mode, you can always turn it on and
return to lastly displayed chart by pressing ‘ON/OFF’ button.
Power OFF – new power saving feature.
TCP-2000 Chart Panel will turn itself off when not used after preset time. This
time is set in factory to 2 hours. Service personnel can adjust it during installation
to 30min, 1h, 2h, 3h and 4h depending on the customer needs. If TCP-2000 is in
off-mode LED on the front panel is also off.
NOTE !