INSPECTION AND MAINTENANCE
73
10
2.
O-ring
3.
O-ring
4.
Filter
5.
Float
6.
Cup
7.
Indication of Fuel Flow.
2. If present, disconnect hoses from the
fuel connector (male) and the fuel
pump.
3. Remove the cup, filter and O-rings
from the fuel filter body.
4. Check the wear and clogging for each
parts, and replace if necessary.
5. Remove fuel and any water or debris
from the cup, filter and hoses.
6. Reassemble all parts.
ENOM00096-A
Fuel filter (for fuel tank)
Water or dirt in the fuel tank will cause
engine performance problems.
Check and clean the tank at specified
times or after the outboard motor has
been stored for a long period of time
(over three months).
1. Remove four screws to remove the
Fuel Pick-Up.
2. Clean the fuel filter and replace the
gasket.
3. Reassemble all parts.
1.
Fuel pick-up
2.
Filter
ENOM00098-A
Gear oil replacement
ENOW00094-0
z
Be sure that outboard motor is secured to
transom or service stand, or accidental
drop or fall of outboard motor could lead
to severe personal injury.
z
Be sure to lock outboard motor if it is
tilted up, or accidental fall of outboard
motor could lead to severe personal
injury.
z
Do not go under outboard motor tilted up
and locked, or accidental fall of outboard
motor could lead to severe personal
injury.
1. Tilt down the outboard motor.
2. Remove the oil plugs (lower and
upper), and completely drain the gear
oil into a pan.
WARNING
2
1
ENOF00926-A
