ENGINE OPERATION
39
7
ENOW00959-0
The top cowl must be installed while the
engine running except in an emergency. If
the top cowl is not installed correctly, water
splash can damage the engine.
ENOW00036-A
When the engine is started in the test tank,
to avoid over heating and water pump dam-
age, be sure the water level is at least 10 cm
(4 in.) above the anti ventilation plate.
Run the engine only at idling.
And be sure to remove the propeller, when
star ting the engine in the test tank. (See
page 74)
Run the engine only at idling.
1.
Test tank
2.
Water
3.
Over 10 cm (4 in.)
ENOW00036-0
Be sure to stop engine immediately if cooling
water check port is not discharging water,
and check if cooling water intake is blocked.
Operating engine could lead to overheating
potentially leading to engine damage. Con-
sult an authorized dealer if the cause cannot
be found.
ENOW00974-0
Starter motor will not operate if the stop
switch lock is not properly installed.
This model is provided with start in gear
protection.
ENON00010-0
Note
Start-in-gear protection prevents engine
from starting at other than neutral shift.
In-gear starting of engine will move the
boat immediately, potentially leading to
falling down or causing passenger(s) to be
thrown overboard.
ENOM01806-0
Tiller handle type
1. Be sure to install the stop switch lock
to the stop switch, and attach the
stop switch lanyard securely to the
operator or to the operator's PFD
(Personal Flotation Device.)
1.
1.
Stop switch lock
2.
Main switch key
2. Insert the main switch key.
CAUTION
CAUTION
CAUTION
1
3
2
ENOF00863-0
CAUTION
1
2
ENOF00864-1
