28
INSTALLATION
4
Free Accel
lever
Fully opened
Fully
closed
Approx
. 32
°
Move the shift arm Forward, to
Neutral and to Reverse to confirm
the shift is working, and then set
the shift arm to Neutral.
◎
Screw the tip of the remote control
cable into the cable joint up to
approx.10mm(0.39inch), then lock
them with a lock nut. Here, apply
grease to the hole of the cable joint.
④
Move the Remote Control lever
Forward, to Neutral and to Reverse
to confirm the shift is working, and
then set the lever to Neutral.
◎
Double-check that the Remote
Control Cables, the throttle cable
and shift cable have been connected
correctly. Move the Remote Control
Lever Forward until the first engaging
point (approx. 32˚). The cable which
is moved first when the lever is
turned is a shift cable. Check that
the shift lever is in Neutral and the
Free Accel lever is fully closed
when the remote control cables
have been connected.
⑤
Set the shift arm to the Neutral(N)
position and close the advancer arm
completely.
If the advancer arm does not
contact with the stopper, the
throttle position sensor will be
active improperly.
◎
The advancer arm should have
contact with the stopper at neutral
position of the remote control lever.
R-shaped pin
Washer
Shift cable joint
Shift arm
Throttle cable joint
Cable joint
Lock nut
Remote control cable
Approx. 10 mm (0.39 inch)
Advancer arm
Throttle
position
sensor
Fully closed
Stopper (Throttle fully closed side)
OM_E_MD30B2-115A2_body_111213.indd 28
11/12/13 13:07
