IP-EN1-EB Instruction Manual
16
6
Connection and Settings for the SX-2000 System
6.1 Connections to SX-2000
Rear right side (mandatory indications)
1
Connect CN5 to Status output 2 of the SX-2000SM (use Cat5/5E/6 cable)
2
Prepare an RJ45 connector with connections between the pins: 1-8, 2-7, 3-6, 4-5 and
plug into CN11
3
Connect CN3 to Status output 1 of the SX-2000SM (use Cat5/5E/6 cable)
4
Connect CN10 with power supply from VX-2000DS or VX-3000DS
(don’t connect to
regulated 24 VDC), + on pin 1, - on pin 2
5
Connect to control outputs for EMG status, fuse rupture, power fault, FM fault, network
fault. For details refer to table “CN7 main connections”
6
Connect to control inputs for fault acknowledge, fault reset, EMG start, EMG reset. For
details
refer to table “CN15 connections”
7
Connect
to control output for programmed general fault, pins 1 and 3
CN7 main connections
CN15 connections
Pin no.
indication
Pin no.
indication
1
Power LED
1
Fault acknowledge
2
Emergency mode
2
COM (ground)
3
Fuse rupture
3
Fault reset
4
COM (ground)
4
Emergency pattern stop /
emergency reset
(refer to chapter 3.3)
5
Power fault
5
COM (ground)
6
Fireman microphone fault
6
Emergency pattern start
7
Network fault
For the connections to the SX-2000 components connections refer to 6.2 Connections at
SX-2000 Components on next page.
CN7
CN15
CN9
CN12
CN18 CN13
CN10
R6
1
1
1
1
1
1
3 2 1
R2
R3
R1
CN20
CN6
CN8
CN19
CN1
CN5
CN11
CN3
STATUS OUTPUT 2 STATUS OUTPUT 1
+ -
20-40 VDC
To control outputs for EMG status, fuse
rupture, power fault, FM fault, network fault
To control inputs for fault acknowledge,
fault reset, EMG start, EMG reset
1
2
3
4
5
6
To control output for general fault
7
CN2
