►
www.tmgindustrial.com P11/39 Toll Free: 1-877-761-2819
7. Be a safe and courteous driver. Always yield to oncoming traffic in all situations,
including narrow bridges, intersections, etc. Watch for traffic when operating near or
crossing road ways.
8. Never allow riders on the machine.
3 ASSEMBLING
The machine comes from the factory in a shipping configuration. Always use tools
equipment and forklifts of appropriate size and capacity for the job. Always use 2 men
when lifting, moving and assembling the machine.
When the machine is shipped, follow this proce
-
dure when preparing for the
customer:
1. Clear the area of bystanders especially small children before starting.
2. Use a forklift to lift the pallet/machine from the truck. Carry the load close to the
ground. 3. Move the machine to the assembly area. Be sure there is sufficient clearance
to access the machine from all sides.
4. Cut the tie-down straps.
5. Lay-out components next to machine.
6. Use a forklift to raise and lift the frame.
7. Or alternatively attach a lifting device to the lifting bracket on top of the frame.
8. Remove pallet and place machine on the ground.
9. Tighten anchor bolts to their specified torque.
10. Connect the PTO driveline:
A. Raise the input shaft guard.
B. Check that the driveline telescopes easily and that the shield rotates freely.
C. Attach the driveline to the chipper input shaft by depressing the lock pin, slide yoke
over the shaft and pushing on the yoke until the lock pin clicks into position.
D. Lower the guard to cover the input shaft.
