►
www.tmgindustrial.com P15/39 Toll Free: 1-877-761-2819
2. When cutting the driveline, follow this procedure
:
A
. subtract the machine dimension (A) from the uncut driveline dimension (B) or (B-A).
This dimension determines how much too long the driveline is.
B
. Add another inch (25 mm) to the dimension to be sure it doesn't bottom out, to
determine (C) the cut off dimension.
C
. Use a hacksaw to cut dimension (C) from both ends.Cut both the plastic tubes and the
metal cores. d. Use a file to remove the burrs from the edges that were cut.
E
. Assemble the 2 ends of the shaft.
F
. Make sure the shaft can telescope freely. If it does not, separate the 2 parts and inspect
for burrs or cuttings on the shaft ends. Be sure it telescopes freely before installing.
5.5 TRANSPORTING
1. Comply with state and local laws govern ing safety and transporting of machinery on
public roads.
1. To determine the proper length of the
driveline, follow this procedure:
a. Clear the area of bystanders, especially
small children.
b. Attach the chipper to the tractor but do
not attach the driveline.
c. Raise the machine until the input shaft
is level with the tractor PTO shaft.
d. Measure the dimension between the
locking grooves on the tractor PTO shaft
and the machine input shaft.
e. Measure the same dimensions on the
compressed driveline.
f. If the compressed driveline dimension
exceeds the machine dimension, the
driveline will have to be cut.
CUT OFF DIMENSION
SHORTENING
