►
www.tmgindustrial.com P18/39 Toll Free: 1-877-761-2819
6.1.3 SERVICING INTERVALS
The period recommended is based on normal operating conditions. Severe or unusual
condtions may require more frequent lubrication or oil changes.
8 Hours or Daily
1. Grease PTO driveline.
40 Hours or Weekly
1. Grease the telescoping section of the PTO shaft.
2. Check sharpness of blades:
A. Rotor
B. Stationary Remove, sharpen or switch edge as required.
100 Hours
Grease rotor bearings.
IMPORTANT
Do not over grease.
Annually Clean machine.
6.2 MAINTENANCE
By following a careful service and maintenance program for your machine, you will
enjoy many years or trouble-free operation.
6.2.1 DRIVELINE MAINTENANCE
The PTO driveline is designed to telescope to allow for dimensional changes as the
machine goes through its operational range. A tubular guard encloses the driving
components and is designed to turn relative to the driving components. The driveline
should telescope easily and the guard turn freely on the shaft at all times. Annual
disassembly, cleaning and lubrication is recommended to insure that all components
function as intended. To maintain the driveline, follow this procedure
1. Remove the driveline from the machine.
2. Pull driveline apart.