W W W . T M G I N D U S T R I A L . C O M
P 1 3 / 3 7
T o l l F r e e : 1 - 8 7 7 - 7 6 1 - 2 8 1 9
4 Operation declaration
4.1 Operating notes
Check the connection of air pipe is in place, ensure that no air leakage, ensure the
operation space to meet the requirements, then start work.
Before any operation, the gas in the tire is needed to be released , and the balance
block of the tire balancing device is removed.
4.2 Disassembly operation process
4.2.1 pressing tire
Check whether the gas has been released over. If not, please release the gas
completely, close the clamps on the turntable, and straighten the turntable in order
to avoid the damage to the rim in the process of pressing tire.
As shown in Figure 9,10, the tire need to be leaned on the rubber mat which is on the
right side of the semi automatic tire changer (S), ( Note: it must be very careful to
carry out the pressing operation. When the pressure plate is operated, the pressure
relief arm will swing rapidly and powerfully, and any object in the range of the
pressure arm is dangerous.
As shown in Figure 10, make the pressing-tire spade R close to the rim edge for
Figure10
Figure9
Summary of Contents for TMG-TC24
Page 32: ......
