trolley (for heater - ir20)
model no:
ir20t
thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT:
PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. Safety
i
9
Before each use, check that there is no damage to the trolley and that all fixings and wheels are firmly attached.
8
Do Not
use this item for any purpose other than that it is intended for.
9
Replace or repair damaged parts.
Use only recommended parts. Other parts may be dangerous and will invalidate the
warranty.
2. iNtroDuctioN
optional trolley for model no. IR20.
3. SpecificatioN
model no: .................................................................... IR20T
Size (H x W x d): ......................................350 x 515 x 80mm
nett weight: ................................................................. 3.48kg
4. coNteNtS
5. aSSeMbly
5.1.
TROLLEY AND HANDLE (fig.1, fig.2)
5.1.1.
Following fig.1, assemble the components as shown.
5.1.2.
Following fig.2, assemble the handle (Item B) as shown.
5.2.
MouNtiNG heater
(fig.2)
5.2.1.
Clear out the four screw holes in the heater case that align with the
handle and trolley.
5.2.2.
Use fixings G, H, and I to mount the handle and trolley on either side
of the flange on the heater body.
IR20T Issue 1 21/03/19
Original Language Version
© Jack Sealey limited
Refer to
instruction
manual
ITem
deSCRIPTIon
QUAnTITY
A
Wheel frame (2 sides + 1 end part)
3 pieces total
B
Handle (2 sides + 1 end part)
3 pieces total
C
Axle
1
d
Wheel
2
e
Spacer
2
F
domed wheel nut m12
2
G
H
ex head bolt M4 x 50 long
4
H
Coned washer m4
8
I
locknut m4
4
J
F
lange head bolt M5 x 25 long
4
k
locknut m5
4
fig.1
fig.2
