W W W . T M G I N D U S T R I A L . C O M
P 1 4 / 3 7
T o l l F r e e : 1 - 8 7 7 - 7 6 1 - 2 8 1 9
about 2-3cm, (Note: the pressing-tire spade is to be placed on the wheel rather than
the rim).
As shown in Figure 9, step on the pedal (U) and start the tire pressing device. When
the tire pressure shovel completed operation or the wheel edge goes away from the
rim, release the pedal. Gently rotating the tire, repeat the same operation to the
other place of the tire.
4.2.2 Tire disassembly
After pressing tire, the rim edge should be coated with special lubricating fluid, make
the position of the pedal (VI) be in parallel with (V2), the tire should be fixed on the
clamp (G) , make the clamp lock the rim tightly by steeping on the pedal (V2) (Note:
make sure that the rim is locked tightly by the clamps).
Lower operating arm (M), until the disassembly head (I) is supported on the rim of the
rim, lock it with the lock handle (K). In this process, as shown in figure 8-b, figure 8,
the operating arm (M) is locked in a fixed position in the vertical direction, and the
head (I) is moved to the top of the rim of the 2-3.5mm. Once the operating arm is
locked in the vertical direction, As shown in Figure 14, you must use the left hand
wheel (E) which is on the horizontal swing arm (N) to remove the rim of the head (I)
(about 2-3.5mm).
As shown in Figure 11, insert into the crowbar (T) between the tire edge and the
mounting head (I), make the tire edge hang on the disassembly head (I) outward,
keep the crowbar (T) in this position, slam the pedal (Z) to make turntable (Y) rotates
Figure 8-b
Figure 14
Figure 8
Summary of Contents for TMG-TC24
Page 32: ......
