14
5.0 Ticket Load Procedure
1. Plug the printer into an AC source and it will automatically turn on. The red
CHECK PAPER
led will be
illuminated. You will also hear the cutter knife cycle during this time.
2. Begin loading the tickets through the entrance slot with a smooth motion until the ticket stock comes to
a stop (at this point the stock is between the thermal head and platen). Keep pressure against the
stock and the printer will automatically feed the ticket stock.
Receipt stock with Lemur-Z (with roll holder)
Fan folded stock (with paper guide)
Lemur-Z with paper guide
Lemur-X
3. The printer will feed the stock forward toward the front of the printer and then reverse it back to the print
(idle) position. For use with fan folder stock with black timing mark the stock will loop upwards.
When using ticket stock with a black timing mark the black timing must meet the specifications found on the
following link
www.bocasystems.com/ticket_specs10.html
.
If you have any ticket load issues then make sure the paper guild slider bar is properly adjusted (see
5.1 Ticket
Width Adjustment
).
Click here to return to >
Table of Contents
Feed
Direction
Align paper to
this side wall
Slider Bar
Feed
Direction
Feed
Direction
Slider Bar
The black timing mark on the
back of ticket stock must
pass under this side facing
down towards the opto
