TKH
TKH Security | Siqura EX PTZ Series |
Installation manual v4
7-66
Install the unit
Any action performed on the unit which is not described in this manual may damage it.
Make sure that the installation surface can support at least four times the weight of the
unit in normal operating conditions. In case of excessive external stress (vibration,
strong winds or impact, for example), the equipment may need additional means of
protection.
The PTZ camera station is designed to be mounted in a upright position only (camera-
tube on top). Operation in any other than upright mounting position may cause failures
not covered by its warranty and certification.
Proper stainless steel hardware should be carefully chosen to fasten the unit to the
surfaces. Proper tools should be used during the installation, in accordance to
environmental requirements.
Use caution when lifting and assembling the unit. It is recommended that non-slip
protective gloves be worn during installation. The unit could bear sharp edges.
WARNING: Hazardous moving parts: the device is remotely controlled and may change
position at any time. When installing, choose a place where moving parts cannot hit
anyone or any object, creating hazardous situations.
Open only the covers pointed out in this installation manual. Other covers should be
opened only by the manufacturer.
Electrical connections (such as plugs and cords) must be protected from potential
hazardous environmental factors (e.g. foot traffic, hitting objects).
Pointing the camera at the sun may damage it.
Use appropriate tools for the purpose. The particular nature of the site where the device
is to be installed may require special tools for installation.
Preset Call 99 calibrates the Camera Pots in case of a motorized lens (needed the first
time the camera is connected)
The equipment is not designed for 24/7 continuous pan and/or tilt movement. Wearing
the motors may result in premature pan or tilt failure, not covered by its warranty.