FITTING INSTRUCTIONS
Product:
T13 Outback Deluxe Frontal Protection System
Vehicle:
Holden Colorado 2016+
Part No.
070SB13L32R
For product warranty, please refer to our website, www.tjm.com.au
File: F-13409
Page 15 of 28
28/03/2017
45.
Loosely secure the chassis mount to the winch
frame using the following fasteners:
45.1.
M12 x 1.25 x 120mm hex bolt (1), 1/2"
x Ø1-
1/4” Flat Washer
s (2), M12 Nyloc
nut (1)
45.2.
M12 x 1.25 x 60mm hex bolt (1), 1/2" x
Ø1-
1/4” Flat Washer
s (2), M12 Nyloc
nut (1).
46.
Use as many spacers as required around the
fasteners installed in step 45 to fill the void
between the chassis mount and winch frame.
47.
Tighten all fasteners to the values specified on
page 1.
48.
Repeat steps 44 - 47 for the opposite side of
the vehicle.
49.
Fit clamp Angle bracket to inboard face of
winch frame and washer plate to front using
M12 x 1.25 x 35mm bolts (3), 1/2" x Ø1-
1/4”
Flat Washers (6) & M12 nyloc nuts (3).
IMPORTANT
– FIT M12 BOLT ASSEMBLY WITH
BOLT HEAD ON FRONT FACE.
50.
Align plate with existing holes and tighten to
specified torque. Check holes and slots align
after tightening to allow easy bolt
fitment/clearance.
Repeat on opposite side of vehicle.
STEP 45.1
STEP 45.2
INSERT
SPACERS AS
REQUIRED
Holes must
align
NUTS
TO INSIDE!
RHS SHOWN
RHS SHOWN
RHS SHOWN
