![background image](http://html1.mh-extra.com/html/tivoli-audio/trace/trace_installation-instructions-manual_1120422002.webp)
www.tivolilighting.com tel: 714-957-6101 fax: 714-427-3458
RGBW TRACE™ Horizontal Installation Instructions
7101009
Page 2 of 8
Copyright © 2020 Tivoli 06.23.20
Overview: Read Before Installing Luminaire
Installation Notes:
Step 1:
Measure run area where Trace™ RGBW is to be installed.
Locate power feed end at highest point of the run to minimize
exposure to water run off.
Step 2:
A Mounting Channel is recommended for outdoor
applications. Lay channel along desired area and attach with screws
(by others) every 18 to 24 inches. If the design requires creating
bends and arcs, it is recommended that the Horizontal Notched
Channel be used. Mounting Clips are for use on indoor applications
only.
Note:
Minimum bending diameter for the notched channel is 11”.
Trace™ Horizontal must not be bent less than 2” diameter or damage
will result.
Step 3:
Trace™ must be installed with two people. One to press
the luminaire into the channel and the other to hold the spool and
unroll it while keeping the Trace™ flex body straight.
Warning:
Risk of Product damage.
Do not stretch, pull, or yank. Doing so can damage the Trace™
internal connections and void the warrant
y.
Step 4:
Insert Trace™ into mounted channel starting from power
connector end. The End Cap and Power Feed Connector do not fit
within the channel, so cut the Mounting Channel so that connectors
and End Caps will overhang outside the ends of the Channel. Trace™
should be pressed into the channel carefully and gradually, without
excessive bending or damage will result.
Note:
We recommend using a dry spray lubricant, such as 3M Spray
Lubricant or WD-40 Specialist for all Trace™ installations to insure the
luminaire fits into the channel without damage. Additionally, when
installing with Mounting Clips, Silicone Sealant (
FLXD-SIL-GE-10
)
may be applied to the inside bottom surface.
Step 5:
Secure power connection to building with use of C-clamp
(by others) or mount connection inside J-Box.
Connect to 24V DC power supply according to supplied wiring
diagrams.
Straight
Channel
Notched
Channel
Mounting
Clip