www.tivolilighting.com tel: 714-957-6101 fax: 714-427-3458
RGBW TRACE™ Horizontal Installation Instructions
7101009
Page 7 of 8
Copyright © 2020 Tivoli 06.23.20
Driver
Output
Power
Input
D+
D-
D-
D+ v+ v+ 1
2
3
4
5
DMX in
DMX out
DMX in
DMX out
RJ45 To Master
DMX Controller
(By Others)
RJ45 To next
Sub-Controller
(By Others)
Note:
Connectors located inside box
14ga
Wire
14ga Wire
Settings
Display
DMX512 & RDM Decoder
To Power Supply (Neg. Wire)
To Circuit Breaker (Pos. Wire)
XLR DMX in/out
RJ45 DMX in/out
Output for LED
DC Power Input
Screw DMX in/out
Digital Display
Lead Wire
Trace™ RGBW Flex Light
BLK (+)
RED
GREEN
BLUE
WHITE
•
DMX512 RDM decoder, RDM function can provide the
interface between DMX master and decoder.
•
OLED Display
for example, DMX decoder’s address may be set from DMX
master console.
•
Multiple kinds of DMX in/out ports: RJ 45, XLR , normal screws.
•
Total 5 PWM output channels, common anode. DMX channel
quantity from 1CH~5CH programmable
•
PWM output resolution ratio 8bit , 16bit settable.
•
Output dimming curve gamma value from 0.1 ~ 9.9 settable.
•
Programmable Decoding mode.
Safety and Warnings:
•
Do not install with power applied to device.
•
Do not expose to moisture.
Note:
The Installation Instructions for your power supply includes
DMX programming instructions.
Trace™ RGBW Basic Wiring Diagram
Elecrical Connections for Trace™
RGBW
Step 1:
Turn power off before beginning electrical installation.
Note:
Contacting hot wires against the Trace™ leads may damage the
product and void the warranty.
Step 2:
Connect Trace™ lead wires to RGBW-Sub-Controller, or
if using our ADUL-DIN series transformers, connect to pre-wired
connectors which are found inside the power supply box. Refer to
diagram below and on Page. Make sure each lead wire is connected
to the correct terminal, as follows:
LEAD WIRE
COLOR
SUB-CONTROLLER TERMINAL OR
ADUL-DIN CONNECTOR WIRE COLOR
Black
Black (+)
White
Blue
Red
Red
Green
Green
White
White
Step 3:
Connect to a listed Class 2, 24V DC transformer only. See list
of approved transformers.
Step 4:
Optionally, Trace™ RGBW may be dimmed using an MLV or
ELV dimmer that is suitable for the power supply. Please contact our
technical support staff for more information.
Connect to
Tivotape
Dr
iv
er
O
utput
Po
w
er
Input
V+
XLR Connectors
RJ45 Connectors
DMX
in/out
DMX
in/out
Hard Wire
Connection
