www.tivolilighting.com tel: 714-957-6101 fax: 714-427-3458
RGBW TRACE™ Horizontal Installation Instructions
7101009
Page 3 of 8
Copyright © 2020 Tivoli 06.23.20
Trace RGBW Mounting Options
Screws
(Included)
Mounting Clip
Bending direction for Trace™ Horizontal
Tape Light
Trace™ Horizontal with Mounting Clips
Warning:
Risk of Product Damage.
Only bend the Trace™ RGBW Horizontal so the lens bends side to side.
See diagram below.
Note:
Minimum bending diameter for Trace™ Horizontal is 2” in the
horizontal direction only.
Step 1:
Determine where the Mounting Clips will need to be installed
to achieve the desired shape.
Step 2:
Position the Mounting Clips and attach with screws
(Included).
Step 3:
Lay a bead of Silicone Adhesive (
LFXD-SIL-GE-10
) to the
inside bottom surfaces of the Mounting Clips, as shown.
Step 4:
Spray Dry Lubricant on a rag and wipe the inside upper
surfaces of the mounting clips, as shown, to allow the Trace™ fixture
to slide more easily into the mounting clip. 3M Spray Lubricant or
WD-40 Specialist is recommended.
Warning!
Risk of Product Damage.
Regular WD40 490002 will stress craze, crack or swell the Trace™
Silicone covering. Do not use!
Step 5:
Trace™ must be installed with two people. One to press
the luminaire into the channel and the other to hold the spool and
unroll it while keeping the Trace™ flex body straight.
Step 6:
Press Trace™ into the Mounting Clip carefully and gradually,
without excessive bending or damage will result.
WARNING!
Risk of Product Damage.
Do not hammer or pound the luminaire into the channel. Once
inserted, do not pull or yank on the fixture. Trace™ will be damaged
unless it is handled carefully.
Step 7:
Connect to power.
Bending Limitations
Warning!
Risk of Product Damage.
Trace™ RGBW Horizontal can only be bent in the direction that does
not twist the Tape Light.
X