Operating the riveting tool
22
E
6
Z
13
a
Z
90
Setting the blind rivet
Note
The tension head and blind rivet you implement may look a
little different than shown in the following illustrations
Attention
Material damage! Always set the riveting tool at the correct
angle (90°) with the surface of the work-piece to be riveted.
A slanted setting will lead to defective riveting.
Note
For the size of the hole (d1) and of the clamping grip (K), refer
to the information given by the rivet manufacturer
• Connect compressed air (6 bar).
• Insert blind rivet (a) in tension head (Z).
• Insert blind rivet (a) into the prepared bore and press tightly.
• Straighten the trigger (13) upto the stop point, and hold it there.
The rivet shaft is clenched and the blind rivet set by.
• Releasing trigger (13).
The torn off mandrel is transported latest after the next riveting process
into the collector (6).
90
d1
d
K max
K min
a
Z
