Titan TTI932CHN, Manual

Page: 31 / 60

31
TTI932CHN
In
more
detail...
EN
Product functions
Chain brake test
WARNING! Before operating this product, always check that the
chain brake is in perfect working condition!
The following function check should be carried out before each use. The
purpose of the chain brake testing is to reduce the possibility of injury due to
kickback.
1. Make sure the chain brake is disengaged. Disengage the chain brake by
pulling the front safeguard (chain brake lever) (4) back towards the front
handle (3).
2. Place the product on any suitable flat surface, make sure the saw chain (11)
is not touching the surface or other objects.
3. Attach the battery pack (23).
4. Hold the product with left hand on the front handle (3) and right hand on the
rear handle (1) (Fig. 18).
Fig. 18
5. Press the lock-off button (16), then squeeze the on/off switch (17) to switch
the product on and wait until it runs at full speed.
6. While the motor is running, engage the chain brake by rolling your left hand
forward against the front safeguard (chain brake lever) (4). The saw chain
(11) should stop immediately.
WARNING! The motor will not start if the chain brake is in the
engaged position.
WARNING! If the saw chain (11) and motor fail to stop when the
chain brake is engaged, take the product to the nearest authorised
service centre or a similarly qualified person! Do not use the
product if the chain brake is not in working properly!
The chain brake should not be used for starting and stopping the
product during normal operation!