42
In
more
detail...
EN
TTI932CHN
operate it if you find broken and worn parts.
WARNING!
Only perform repairs and maintenance work according
to these instructions! All further works must be performed by a
qualified specialist!
General Cleaning
1. Clean the product with a damp cloth and pH-neutral soap. Use a brush for
areas that are hard to reach.
2.
In particular clean the air vents (21) after every use with a cloth and brush.
3.
Remove stubborn dust with high pressure air (max. 3 bar).
NOTE:
Do not use chemical, alkaline, abrasive or other aggressive
detergents or disinfectants to clean this product as they might be
harmful to its surfaces.
4. Check for any damage and wear. Repair damages in accordance with this
instruction manual or take it to an authorised service centre before using
the product again.
Sprocket wheel
NOTE:
It is not necessary to remove the saw chain (11) to lubricate
the sprocket wheel (12a). Lubrication can be done on the job.
1. Clean the sprocket wheel (12a).
2. Using a disposable lube gun, insert the needle nose into the lubrication
hole (12b) (Fig. 38) and inject grease until it appears at the outside edge of
the sprocket wheel (12a).
3.
11 12
12a
12b
Fig. 38
4. Rotate the saw chain (11) by hand. Repeat the lubrication procedure until
the entire sprocket wheel (12a) has been greased.
Care and maintenance
Summary of Contents for TTI932CHN
Page 60: ......
