TTI932CHN
26
Getting
started...
EN
Chain lubrication
WARNING!
The product is not filled with chain oil. It is essential
to fill the product with chain oil before using it! Never operate the
product without chain oil as this will result in extensive damage to
the product!
Operating the saw chain dry or with too little chain oil will decrease
cutting efficiency, shorten the product life span and cause rapid
wear to the saw chain and guide bar from overheating!
Insufficient chain oil is evident by smoke or bar discoloration!
Adequate lubrication of the saw chain during cutting operations is
essential to minimise friction with the guide bar!
1.
Place the product on a stable, level surface with the oil tank cap (2) facing
upward. We recommend laying a non-flammable sheet under the product.
2.
Unscrew and remove the oil tank cap (2) (Fig. 9).
2
15
Fig.9
3.
Fill suitable lubricant into the tank using an oil funnel fitted with a filter to
avoid debris entering the tank. We recommend using environmentally
friendly chain oil specially intended to be used with this product.
NOTE:
In summer use SAE #30; in winter, or if the trees have
excessive sap, use SAE #10.
4.
Don’t fill the oil lower than the oil level window (15), but also do not overfill
or and leave approximately 5 mm of space between thetop of the oil and
the inside edge of the tank to allow for expansion (Fig. 10).
Before you start
Summary of Contents for TTI932CHN
Page 60: ......
