Titan TTB591ROU, Safety And Operating Manual

Page: 14 / 20

6. FiTTinG THE PaRaLLEL GUiDE (See Fig. 8)
Before using the parallel guide you will need to
assemble the guide. Remove the two screws and
washers from the end of the two bars and fit the
guide to the bars using the washers and screws you
removed. Tighten screws securely. Insert the bars
into the grooves in the base of the router. Adjust the
guide to the required cutting width and tighten the
two parallel guide locking screws.
7. FiTTinG THE CEnTRinG Pin anD
MaKinG CiRCULaR CUTS (See Fig. 9 &
Fig. 10)
The centring pin allows you to make circular cuts.
(a) Fasten the centring pin on the parallel guide but
upside down.
(b) Push the guide shaft of the parallel guide.
(c ) Place the centring pin against the material.
(d) Set the required radius by adjusting the shaft
of the parallel guide and tighten the parallel guide
locking screws.
(e ) Fixing router in required depth with the plunge
lock lever.
(f ) Switch on the machine.
(g) After releasing the plunge lock lever, lower the
machine slowly.
(h) Cut grooves, shoulders, etc at a steady rate of
feed, holding the machine with both hands.
(y) When finished, raise the machine again.
(j ) Switch off the machine.
8. USinG THE GUiDE BUSH (See Fig. 11)
Use this attachment to cut out a shape using a
pre-formed template (ie a worktop jig). Fix the Guide
Bush to the router base using the two long screws
provided. Thereafter use the instructions provided by
the template manufacturer.
Fig. 9
Fig. 10
Fig. 11
Fig. 5
Fig. 8
Fig. 6
Fig. 7
a
b