ROUTER 1250W
TTB591ROU
Failure to follow this advice can lead to serious injury
as the router bit may not be properly secured in the
collet, or may damage the collet.
The router bit must suitable for the speed of the tool!
Never use the bit over its rated speed in anytime.
4. aDJUSTinG DEPTH oF CUT (See Fig. 5
& Fig. 6)
The depth of cut is the distance between the turret
depth stop and the depth stop bar. Router bits vary
in depth, the turret depth stop allows for this with its
eight positions. Use one of the two following methods:
Method 1: Using a piece of wood method.
Fit the router bit, loosen the depth stop bar fixing
screw, pull the plunge lock lever up and plunge
the router down until it comes into contact with
the workpiece. Lock the router into this position
by pushing down the plunge lock lever. Lift up the
depth stop bar and insert a piece of wood the same
thickness as the depth of cut between the stop bar
and triple stop bar.
Tighten the depth stop bar fixing screw (a) and
release the plunge lock lever to return the router back
to its original position. The depth of cut is now set,
see “Starting the router” section for final operation.
Method 2: Using the scale method
Fit the router bit, loosen the depth stop bar fixing
screw and release the plunge lock lever. Lower the
router down until it contacts the workpiece, lock into
this position with the plunge lock lever. The scale on
the depth bar now shows the starting position. Note
the starting position will vary depending on the bit
used. Next add the required depth of the cut to the
starting position, i.e.: if the scale shows 20mm and
you require a cut of 10mm, then the correct
adjustment on the scale is 20+10=30mm, if the scale
shows 38mm and the required cut is 6mm in depth,
the adjustment on the scale will be 38+6=44mm.
Now move the depth stop bar to the calculated
number, and lock bar with the fixing screw. Release
the plunge lock lever, the router will return to its
original position.
5. MaRKinG FinE aDJUSTMEnT To CUT
DEPTH (See Fig. 7)
If you want to make some accurate adjustment,
micro-adjustment can be made by turning the micro
depth adjustment knob (b).
Fig. 5
Fig. 8
Fig. 6
Fig. 7
a
b
Summary of Contents for TTB591ROU
Page 1: ...ROUTER1250W TTB591ROU SAFETY AND OPERATING MANUAL Original Instructions...
Page 2: ......
Page 20: ......