Titan TTB427GTM, Safety And Operating Manual

Page: 16 / 26

POLE HEDGE TRIMMER 400W TTB427GTM
3). HARNESS
WARNING! Always operate using the harness
provided. Failure to do so could result in loss of
balance and result in personal injury.
a). Open the securing clip (6) to remove the harness from the
loop.
b). Place the harness so that it runs over the left shoulder,
crossing the chest and back. (See Fig. 2a)
c). Locate the product to the harness by using the securing
clip.
d). Adjust the position of the upper securing clip loosening
the fixation knob anticlockwise and sliding it into required
position. (See Fig. 2b)
e). To allow safe and comfortable use, the lower shaft should
be adjusted so that the upper and lower Harness Securing
Clips (6) are approximately the same width as the user’s
shoulders.
NOTE
: The lower adjustable section is NOT to increase the
cutting length but to alter the harness positions.
3. CABLE ROUTING
1). Always route the electric main cable away from the work
area to prevent it from coming into contact with the blade.
Plan your route before starting work. Start your work at the
nearest point to the electrical outlet, and work away from it.
This will keep the cable away from the tool and avoid it being
accidentally cut. Keep the cable over your shoulder for added
safety.
2). For tension relief of the cable, form a loop of the end of the
main cable and bring this through the opening at the handle
and insert it into the cord strain relief (12). (See Fig.3)
4. POWER CONNECTION
WARNING! Before operating the pole hedge
trimmer, ensure that the fastening elements are
undamaged. In order to prevent risk, always
switch off the motor and pull out the mains plug before
starting this task.
Fig. 2a
Fig. 2b
Fig. 3
400w 高枝.indd 16 12-3-2 上午11:36