Titan Leaf Pro, Operation & Maintenance Manual

Page: 60 / 139

General Operating Instructions
7.4. DISCHARGE CHUTE CYLINDER (IF EQUIPPED)
The hydraulic discharge chute is operated by the control lever located on the bearing doghouse.
NOTE: FOR ELECTRIC OVER HYDRAULIC SYSTEMS, THE ENGINE NEEDS TO BE RUNNING TO RAISE
THE CHUTE.
During operations, it is recommended that the discharge cylinder toggle switch be left in
the float position to accommodate variations in towing conditions. NOTE: FLOAT LEFT ON WILL
DRAIN BATTERY.
7.5. WETTING SYSTEM (IF EQUIPPED)
The wetting system is designed to reduce the amount of dust exiting the discharge nozzle. A simple
on-off switch to operate the pump is located on or near the engine control center.
Three spray nozzles are located on the discharge chute. The amount of water being sprayed can be
changed by turning some of these nozzles on or off. Ball valves are located near the nozzles on the
discharge chute.
7.6. DUAL TONGUE SYSTEM (IF EQUIPPED)
The dual tongue system is designed for use where off-set operation is required, and consists of a rigid
operation tongue, and a longer removable transport tongue.
When transporting, select the shortest possible length and pin in place. Mark this hole for future
reference.
For operation mode, unpin the transport tongue, pull out fully, and drop to the lower tapered receiver tube.
Caution: Transport tongue is heavy! Get help when moving tongue. Reinsert tongue fully and pin in place.
Hook truck up to operation tongue.