11
Fig. C
Cylinder Loop
9) Install the SHEAVES with AXLES under the Powerside Runway and route cables. (Refer
to Fig. D)
Fig. D
10) Route the Cable ends through the ends of each Crossbeam over the SLACK SAFETY
PIN by removing the pulley assembly, then to the top of each column. Reinstall pulley
after cable has been routed. Tighten the nut using Hex Nuts and Flat Washers at the
ends of the cable. (See Fig. E)
Crossbeam Pulley Removal
Crossbeam Pulley Re-installation
Summary of Contents for HD4P-12000
