15
Fig. M
28) Install the front tire stops at the forward side of the lift using hex bolts, nuts and
washers. Torque to 35-45 ft. lbs. (See Fig. N)
Fig. N
Pin
Runway
Approach Ramp
Front Tire Stop
Hex
Bolt
FINAL ASSEMBLY
LEVELING/SYNCHRONIZING
29) Install the approach ramps on the entry side of the lift. (See Fig. M)
INSTALLATION HINT:
Remove C-clip from ramp pin, slide pin through ramp and runway,
replace C-clip.
30) Using an engineer’s automatic Level (transit), locate the Level, at a convenient location
in the shop that allows an unobstructed view of all four corners of the runways.
31) Follow the Level manufacturer’s instructions for proper setup of the Level. Be sure it is
ADJUSTED LEVEL in all directions.
32) Raise the lift approximately 30”- 40”. Then lower lift until all locking latches are engaged
in each column and the runways are in full down position on locks.
33) Place a Level target on the right/front corner of the runway. (See Fig. O)
34) Beginning with “A” position, sight the level to the target and mark the number or the
graduation on the inch scale of the target that aligns to the cross hairs of the level (See
Fig. O)
Summary of Contents for HD4P-12000
