Use and Maintenance
UM-4
Warnings and legal notes
Before incorporating the partly completed machinery, we recom-
mend consulting this chapter carefully, in addition to the assembly
manual supplied with the individual modules. The information con-
tained in this chapter and in the manuals for the individual modules,
is provided by highly qualified and certified personnel, possessing
adequate competence in incorporating the partly completed ma-
chinery.
Avoid damage. Do not operate with inadequate tools
Precaution in installation and handling operations. Signifi-
cantly heavy equipment.
When handling the axis or system of axes, always make sure
that the support or anchoring surfaces do not leave room
for bending.
In order to stabilize the axis or system of axes, before han-
dling it is mandatory to securely block the mobile parts.
When moving axes with vertical translation (Z AXES) or
combination systems (horizontal X and/or more than one
vertical Z), it is mandatory to use the vertical movement to
put all of the axes at the corresponding lower limit switch.
Warning: moving parts. Do not leave objectson the axis
Do not overload. Do not subject to torsion stress.
Do not leave exposed to atmospheric agents.
Special installations: check the depth of the threads on
moving elements
Make sure that the system has been installed on a level
floor surface.
In use, accurately comply with the specific performance
values declared in the catalog or, in particular cases, the
load and dynamic performance characteristics requested
in the phase prior to design.
Before mounting the motor on the gearbox, it is advisable to
perform a pre-test of the motor itself, without connection to
the gear unit. The testing of this component was not carried
out by the manufacturer of the machine. It will therefore be
the responsibility of the customer of Rollon to perform the
testing of the same, in order to verify its correct operation.
For modules or parts of modular systems with vertical
movement (Z axis), it is mandatory to mount self-braking
motors to neutralize the risk of the axis dropping.
The images in this manual are to be considered merely an
indication and not binding; therefore, the supply received
could be different from the images contained in this man-
ual, and Rollon S.p.A has deemed it useful to insert only
one example.
Systems supplied by Rollon S.p.A. were not designed/en-
visaged to operate in ATEX environments.
The manufacturer cannot be considered responsible for any
consequences derived from improper use or any use other
than the purpose the axis or system of axes was designed
for, or derived from failure to comply, during incorporation
phases, with the rules of Good Technique and with what is
indicated in this manual.
