Tracking time with your time clock
Arrival
Tap on Arrival. Bring your finger to the reader unit until you hear a signal. If your
fingerprint cannot be identified, the
LED light
1
turns red and you can see an
error message on the display. Tap on
Arrival
to try again. The time clock always
expects to read a fingerprint. Therefore, if you would like to use your transpon
-
der, you have to tap on
ESC
before you bring the transponder to the reader unit.
Departure
Tap on Departure. Stopping a timestamp per fingerprint or transponder works in
the same way as starting one.
Break
Tap on Break
and use either your fingerprint or your transponder to start the
break. Restart the time tracking after taking a break by tapping on
Arrival
and
bringing the transponder or fingerprint as usual to the reader unit.
Other
Tap on Other to record other absences. The respective absence can be selected
in the menu that appears right after. Then bring the transponder or your finger to
the reader unit. In order to change an absence that has been entered mistakenly,
tap again on
Other
.
Info
Here, users can aquire information according to their TimeTac modules. Tap on
Info and bring transponder or finger to the reader unit. Then, information will
appear on your display. Depending on the TimeTac module that you use, your
working time balance
, your
daily balance
or your
residual leave
is displayed.
In general, you can view the
currently running task
and when this timestamp
was started.
If you have defined a timing control, actions (e.g. Arri
-
val, Departure) are preset at specific times of the day. Of
course, any other action can be selected.
i
1
30
31
