8
9
Weathersafe Vision Products
with switches (TGVL01, TGVL02,
TGVL03 and TGVL05)
To take switch apart first remove switch rocker (actuator).
This may be done by inserting a flat blade screwdriver between
the case and rocker as shown in fig. 7 and levering the rocker
off at its pivot point. Be sure to protect the casing under the
screwdriver blade with a piece of card as shown.
Protect the case with card
Concerning TGVL01, TGVL02, TGVL03 only.
If a local neutral is required to give permanent indication
of switch position using the neon supplied, or for wiring
purposes, then use one of the earth terminals shown in
fig. 6 as a neutral wiring terminal.
Note:
This is the only way the neon should be connected.
Fig. 5
– Rocker Removal – TGVL Range
