3
If conduit is to be used then please follow the instructions below:
• The drain feature must be drilled out using a 5mm drill
if top or side entry conduit is used. Opening this drain
hole will reduce the IP rating of the product.
Remember – open out the lower drain feature only
and only if required by conduit entry being used.
• If bottom entry conduit is used, there must be adequate
drainage from the lowest point of the conduit.
• The relevant cable entry knock-out should be unscrewed.
A waterproof cable or conduit entry must then be fitted
in its place.
• If two cable entry positions are used with metal conduit,
then earth continuity between the conduits must
be maintained.
• Ensure that the gasket is correctly fitted, and tighten
the four screws (supplied) to fix the front cover in place
(see fig. 1). Do not over-tighten. Use of an electric
screwdriver is not recommended.
Fig. 1 –
Rear Box (double)
4x fixing holes for
no. 8 wood screws
Drain feature, use only
lower if required
Front cover fixing holes
