10
• The lamp will illuminate for approximately 35
seconds. This indicates the unit is wired correctly.
The unit is in Test Mode when the light turns OFF.
• If the detection area is too small for you
requirements, try angling the PIR light controller
head up. This will increase the detection area.
Angling the head downwards will reduce the
detection area should a smaller coverage be
required.
Setting Up for Automatic Operation
(Auto Mode)
• When walk tests are complete, the unit can be set
into Auto Mode.
• The DELAY TIME ADJUST setting controls how long
the unit remains illuminated following activation
and after all motion ceases.
• The minimum time (fully anti-clockwise) is approx.
3 seconds, whilst the maximum time (fully
clockwise) is approximately 18 minutes.
• Set the control to the desired setting between
these limits.
• The DUSK LEVEL ADJUST control determines the
level of darkness required for the unit to start
operating. The DUSK adjustment knob is indicated
by the ‘Moon’ and ‘Sun’ symbols).
