19 / 45
SERVICE INSTRUCTIONS
TW PTO S426
24.06.2019
2
3
4
GREASE THE DRUM BEARINGS
2
Remove the drum housing guard, situated on the offside of the
1
machine.
Apply two pumps of grease to the bearing taking care not to over
2
grease.
Refit guard.
3
BOTH BEARINGS NEED REGULARLY GREASING.
Turn the discharge tube to point forward of the machine.
1
Using a 24 mm spanner remove the two M16 nuts clamping the drum
2
housing shut.
Carefully lift the drum housing until it rests on its stop.
3
Apply two pumps of grease to the bearing taking care not to over
4
grease.
Lower the top of the drum housing and reinstall the two M16 nuts.
5
Torque these to 65lbft.
6
3
2
TENSION DRIVE BELTS
NOTE: There will normally be a rapid drop in tension during run-in period for new belts. When new belts are fitted,
check the tension every 2 - 3 hours and adjust until the tension remains constant.
Belt failures due to lack of correct tensioning will not be covered under your Timberwolf warranty.
Remove the drum housing guards, (as shown in diagram above).
1
Slacken the six M12 bolts but do not remove (there are three located
2
on each side of the machine).
Slacken the M8 tension nut from the adjuster bracket about 5mm on
3
both sides of roller box.
Tension each of the M8 adjuster nuts drawing the drum housing, roller
4
box and funnel away from the engine bay. For instructions on checking
belt tension & correct belt tension values, please refer to the
Timberwolf V-Belt Tensioning Data (page 31).
Check the belt tension and repeat as necessary.
5
Once belt tension is correct lock off the M8 nut against the tension
6
bracket.
Retighten the six M12 bolts.
7
Refit the belt guard when finished.
8
Summary of Contents for TW PTO/S426
Page 1: ...timberwolf uk com INSTRUCTIONMANUAL TW PTO S426 SHREDDER ...
Page 25: ...TW PTO S426 22 45 DECLARATION OF CONFORMITY 24 06 2019 ...
Page 26: ...23 45 IDENTIFICATION PLATE TW PTO S426 24 06 2019 EXAM PLE ...
Page 29: ...26 45 ELECTRICAL PARTS LOCATOR TW PTO S426 24 06 2019 Date Last Modified 27th July 09 ...
