www.timberk.com • electric metal ceramic fan heater
5
1. Fan heater - 1 pc.
2. Mounting set - 1 pc.
3. Screws set - 1 pc.
4. Remote controller - 1 pc.
5. Operation manual - 1 pc.
6. Guarantee card - 1 pc.
7. Package - 1 pc.
6. SCOPE OF DELIVERY
* for W250. RX / W250. ZM models.
Mounting of the unit is carried out in the following order:
– Mark a true-horizontal line on a vertical smooth wall at the height not less
than 1.8 m from the floor.
– Plot two marks for designed holes along the indicated line with the
distance between them equal to either 57 cm or 65 cm*. Take into account
that upon mounting of the unit its overall dimensions will be larger than
the distance between the marks. It is recommended to leave a free space
within 20 cm and more towards both sides away from plotted marks.
– Drill holes in the wall strictly according to the marks and fit in a plastic
dowel supplied with the unit. Then tighten a mounting screw into the dowel.
– Make sure that the mounting screws are secured properly and mount
the heater on them.
1. «ON/OFF» button. The button is used to switch on/off the unit
2. «SWING» button. The button is used to select rotation louvers hot air outlet.
3. «TIMER» button. The button is used to activate the timer to switch on the unit
4. «HEAT» button. Press this button to select heat flow modes.
1. «MODE» button. Press this button to select heat flow modes.
2. «TIMER» button. The button is used to activate the timer to switch on the unit
7. INSTALLATION
Fig. 1
Fig. 2
Fig. 3
Remote controller for W180.XE model
Remote controller for W200.TQ model
2
2
3
4
5
1
8. UNIT OPERATION
1
2
3
4