www.timberk.com • electric metal ceramic fan heater
7
1. «MODE» button. Press this button to select heat flow modes.
2. «TIMER» button. The button is used to activate the timer to switch on
the unit
3. «ON/OFF» button. The button is used to switch on/off the unit
4. «DOWN» button. The button is used to select the Low power (1000
Watts)
5. «UP» button. The button is used to select the High power (2000 Watts)
6. « » button. The button is used to select the Low power (1000 Watts)
7. « » button. The button is used to select the High power (2000 Watts)
8. «OSCIL» button. The button is used to select rotation louvers hot air
outlet.
9. «CANCEL» button. The button is used to cancel all current settings.
Remote controller for W250.ZM / W250.RX models
1
8
2
4
5
9
3
Fig. 5
Operation by remote controller (for W250.ZM / W250.RX models)
1. Connect the unit’s power cord to a grounded European-standard outlet.
Do not use the unit on uneven and unstable surfaces, nearby combustible,
flammable or easily deformable objects.
2. To switch on the unit, press button « », after that an indicator light
will illuminate on the control panel indicating the activate fan mode. Press
button « » again to switch off the heater.
3. Select a comfortable heating mode by setting the desired heat flow. To
do so, press «MODE» button as many times as necessary to activate the
selected heat flow mode. Indicator lights on the control panel of the unit will
display the modes you select.
4. If it is necessary to set the automatic mode of the air louver control, press
«OSCIL» button on the remote controller. A symbol will illuminate on the
indicator panel. Louvers will start swinging smoothly, changing the air flow
direction and uniformly distributing heat in the room.
5. This heater is equipped with a built-in 8 hour timer function, activated
consecutively. To activate this function, press «TIMER» button on the
remote controller. The timer sets time for operation of the unit. By sequential
pressing of «TIMER» button, you select the time of its operation, upon that
indicator lights illuminate respectively:
0h-1h-2h-3h-4h-5h-6h-7h-8h
6. When the heater is operating, use buttons «+» and « - » to adjust the
temperature. When the room temperature reaches the set value, the heater
is switched off. If the room temperature goes 3°C below the set value, the
heating is resumed.
Pressing «CANCEL» button you cancel the set temperature control. The
temperature is adjusted by pressing «+» and « - » buttons. After switching
IMPORTANT!
The manufacturer can alter the appearance of the
remote controller without prior notification of the user to
introduce modifications and improve its external design.
After switching off, the unit will operate in the fan only
mode to cool down heating elements for about 30
seconds. Then the fan heater will be switched off.