Timberk T-HU3.4-A11M-SV, Instruction Manual

Page: 18 / 40

IM2021
18
•
Before cleaning the appliance, make sure it is unplugged. Otherwise, it may result
in electric shock.
•
Before cleaning, in order not to burn your hands, wait until the water in the base of
the appliance has completely cooled.
•
Use a damp and soft cloth to wipe the outside of the appliance.
• To avoid electric shock, do not scratch or damage the components of the device
when cleaning.
• Do not use solvent, gasoline, dimethylbenzene, hard brush, talcum powder and
other substances when cleaning the device.
•
Wipe off any remaining water inside the base of the unit under the tank with a
damp and soft cloth.
•
To remove water on small parts, you can use a brush and then wipe them again
with a soft cloth.
•
Clean the device once or twice a week.
• If dirt is formed on the membrane, clean it with a brush.
•
Rinse the water tank cover and nozzle carefully and effortlessly with fresh water,
otherwise this will cause water to leak through the cover.
•
After removing any remaining water from the surface of nozzle, wipe it with a soft
cloth.
•
Clean the outside of the appliance with a damp and soft cloth.
IMPORTANT!
• To avoid deformation of working surfaces, resulting in decreased atomizing or
other malfunctions, do not use metallic brushes, blades or talc powder to wipe the
atomizer’s surface.
•
The water tank may leak after heavy impacts.
• In case of water leakage, immediately stop using the unit and contact an
authorized service center.
• To keep the unit dry, wipe the water after cleaning and dry the unit’s base and
water tank. Make sure that there is no water left inside the unit’s base and water
tank.
• Before a long break in use, dry the base and the tank, but the tank on the base and
pack the device in a plastic bag, then put it in a box.
• Store the unit in a low - humidity room.
•
Storing the unit undried results in generation of mold.
To clean the water tank and parts of the base of the device from salt deposits, use
citric acid:
• for 1 liter of hot water, take 1 tablespoon of citric acid and mix well;
•
pour the solution into the tank and put it on the base of the humidifier (water from
the tank will automatically fall into the base of the device);
•
leave the humidifier for 10 - 12 hours - do not turn it on;
• after the time has passed, remove the solution from the device along with the
exfoliated parts of the salt coating;
• if it is difficult to remove plaque - use a special brush for the base of the humidifier
(if this is not supplied, you can use a toothbrush). For the tank - pour 0.5 - 1 cups of
dry rice into cold water or a cooled citric acid solution and shake until the plaque is
peeled off;
• rinse all internal parts of the device with cool water;