Timberk T-HU3.4-A11M-SV, Instruction Manual

Page: 19 / 40

IM2021
19
•
use a humidifier as usual after the procedure.
10. TROUBLESHOOTING
Possible malfunctions and solutions for them are given in table 2.
If the malfunction cannot be resolved in accordance with the recommendations or if
other malfunctions occur, contact an authorized service center.
Table 2
Malfunction Possible cause Solution
Poor atomizing (insufficient
productivity)
The unit is operating in
the low atomizing mode
(low
atomizing frequency)
It is not a malfunction.
Switch the device into the
intensive mode of
operation
The atomizer is clogged Clean the atomizer.
Temperature of water in
the
tank is low
Set maximum productivity
mode. The humidifier’s
productivity will go up after
a while.
No atomizing
The power cord is poorly
connected to the outlet
Connect the power cord
into
the outlet carefully
There is white patches
from the water on objects
around the humidifier
(salts, separating out from
water)
White patches have
formed on the membrane
Clean the humidifier’s
membrane with a special
brush
There is a lot of salts in the
water (calcium and
magnesium)
Use filtered water
Steam has a bad smell
Stale water is used
Clean the unit according to
the cleaning and servicing
instructions and fill the tank
with fresh and filtered
water
Remains of stale water or
waste have accumulated in
the unit’s case or the
atomizer
During the operation of the
device, condensate is
forming on the upper part
of the humidifier
and on surrounding
objects
High humidification
intensity is set.
Decrease the
humidification
intensity Room humidity and
room temperature are high
During the operation of the
device water appears next
to it
High humidification
intensity is set.
Decrease the
humidification
intensity
The water tank is badly
installed on the unit’s base
and there is a gap between
them.
Turn off the unit and make
sure the water tank is
installed correctly on the
base, without any gaps
between the tank and the
base.
White patches have formed Clean the unit according to