Timberk T-HU3.4-A11M-SV, Instruction Manual

Page: 17 / 40

IM2021
17
Fig. 3
Appliance turning on
Install the device true vertically on a flat dry surface, then connect the device to the
electric power network, having previously filled the tank with water. Rotate the knob of
the on/off and steam output intensity regulator to the rightmost position. The appliance
is on, the indicator light is on and steam comes out of the dispenser. At the very
beginning of this operation, the spray level may be unstable due to temperature
differences and water quality. It will take a short time to stabilize.
Steam output intensity adjustment
Rotating the knob of the on/off and steam output intensity regulator to the left and right,
you can adjust the steam intensity. The more steam comes out, the stronger and faster
the air is humidified. Comfortable conditions are achieved at relative air humidity of 40
to 60%. You can determine the favorable level of humidity according to your own
feelings, or you can use a hygrometer (not included in the scope of delivery), which
measures the level of relative humidity.
Automatic shutdown in case of water lack
When the water level in the tank falls below the minimum permissible level, the
ultrasonic membrane of the appliance will automatically turn off and a red indicator will
light up on the control panel. To continue the appliance operation, it is necessary to fill
the reservoir with water according to “Filling the tank with water” section, thereafter
connect the appliance to the electrical power network.
Color lighting
When the lighting is turned on, different colors will change in sequence. To turn on the
color lighting, press the lighting on/off button. To turn off the color lighting, press the
lighting on/off button again.
Appliance turning off
To turn off the appliance, set the knob of the on/off and steam output intensity regulator
to the “OFF” position, and the indicator light will turn off.
NOTE:
When using the air humidifier, you may come across condensate formation on its
upper part and things near it, including water accumulation, which is not a defect, this
is normal side effect of operation. This effect may be related to several causes,
specified in the table “Troubleshooting”.
9. CLEANING AND MAINTENANCE