ENGLISH – Tiki start
31
4.4 Calibrate the blower
1. Perform this procedure before using the mask, hence before entering the
environment with the hazardous mixtures.
2. To calibrate the blower, push the ‘button for the lights’ (11c) followed by the ‘on /
off button’ (11a on figure 11) for six (6) seconds until the lights stop flashing.
3. If calibrated, the following occurs:
› The red indicator lights flash, refer to 11d on figure 11
4. Test the seal of the mask as to the procedure:
4.5 Testing the mask during use on page 32.