30
Tiki start – ENGLISH
4.3 Put the Tiki start on
1. If not already done so:
a. Read the user manual, entirely.
b. Prepare the mask as to the procedure:
3.2 Prepare the mask for use on page 25.
c. Charge the battery as to the procedure:
4.1 Charge the batter(y)(ies) on page 28.
2. Before use,
a. Calibrate the blower as to the procedure:
4.4 Calibrate the blower on page 31.
b. Test that the seal of the mask is tight as to the procedure:
4.5 Testing the mask during use on page 32.
3. Ensure that the mask is cleaned as to the procedure:
5.1 Cleaning the Tiki start on page 35.
4. Check the mask for mechanical integrity, if the Tiki start is not ok, either perform
the procedure at:
5.3 on page 37 or dispose the mask as to: 6 Disposal on page 38.
5. Obey the safety indications in chapter 1 and specific to paragraph:
1.3 Before use on page 5.
6. As necessary, tighten long hair in a hair-knot.
7. Loosen the straps of the harness a bit.
8. With one hand, hold the outer front of the mask, refer to figure 9.
9. With the other hand, hold the inner part of the harness, refer to figure 9.
10. Pull with both hands the mask to its widest stretch.
11. Hold both hands with the mask above the head and bring both hands down: the
mask in front of the face and the harness to the back of the head.
12. Position the front of the mask to a comfortable position on the face.
13. Tighten the straps of the harness again from top to bottom, refer to figure 10.
Do this to ensure a tight seal between the mask and the face of the user, please
note that over tightening makes the mask uncomfortable.
30°
30°
