TigerStop TigerCrossCut, Installation Manual

Page: 10 / 32

10
-OR-
For Eccentric Pin
Style Saws
If you are installing TigerCrossCut to an Altendorf F45, skip to page 12 for installation instructions.
5. Perform lock out/tag out procedures on your table saw.
6. Remove the existing crosscut fence from your saw.
Note: Ensure the mounting surface is clean and smooth. Nothing should prevent a tight fit.
7. There will now be two empty mounting holes where the existing crosscut fence was mounted.
Note: You may have only one empty hole and an eccentric pin. This is OK as well. If you don’t have any empty mounting
holes, you may need to modify your sliding bed.
8. Locate the two sets of alignment cones. Test each set to find the size that fits best in your empty
mounting holes.
Note: TigerStop sends a 15 mm set and a 20 mm set. Modification of the cones may be necessary for other size holes.
15 mm 20 mm
-OR-
9. Set TigerCrossCut on your sliding bed, face down, so the mounting slots are exposed.
Note: Place TigerCrossCut with the motor box away from the saw blade.
10. Insert two T-bolts into the mounting slot of TigerCrossCut and align them with the empty holes.
Note: If you have one empty hole and an eccentric pin, use one T-bolt and the included custom T-nut.