Tiger WILDKAT JD6105-25E T4F, Manual

Page: 47 / 240

ASSEMBLY
Assembly Section 2-17
WHEEL WELL HYDRAULIC TANK INSTALLATION
Install all fittings and tubes into tank and tank filter as shown in the Parts Section illustration.
Insert tank sight glass onto the tractor side of the tank.
Place the tank in the mounting bracket on the axle brace as shown in the Parts Section.
Secure the tank with the hardware provided.
Install the filter gauge into the filter housing so that it points to the rear of the tractor and is
clearly visible to the operator. The tank breather cap is ready for use as the tank is filled. Some
of these items may already be installed.
(ASM-C-0103)
WHEEL SPACERS
When mounting a boom mower, a spacer kit is needed for both rear wheels (part #
06200637). After removing the wheels attach the spacer to the wheel portion of the axle with the
hardware provided. When you are ready to re-attach the wheel, the wheel goes on first then the
reinforcement ring and finally the hardware provided.
(ASM-JD-0099)
INSTALLING O-RING FITTINGS
Installing straight, 45º and 90º O-rings requires that the O-ring and washer be up against the
swivel body. Insert the swivel and turn in until the swivel is pointed in the desired direction and O-
ring contact is made. Hold swivel in set direction with a wrench and turn the O-ring nut away
from the swivel body and carefully tighten.
(ASM-C-0056)
GENERAL HOSE INSTALLATION
Refer to the Parts Section for detailed information about hoses and fittings for this
application.
(ASM-C-0011)
HOSE COVERING
Secure hoses together with zip ties wherever loose. Wrap the hoses between the swivel and
main boom with the hose cover provided. Wrap the hoses between the main boom and
secondary boom with the hose cover provided. Where hoses may contact the frame or other
edges, wrap with split hose and secure with hose clamps or zip ties.
On non-cab units, the pressure and return hoses from the control valve will also need to be
routed inside the protective hose wrap. Cover the valve and valve fittings with the hose cover
and secure with the string provided.
(ASM-C-0058)
TEMPERATURE GAUGE MOUNTING
(OPTIONAL)
Mount the temperature gauge where it is clearly visible to the operator. Attach the green (-)
wire from the negative post on the gauge to a grounded bolt on the tractor frame. Remove paint
if needed to make a good ground. Remove the pipe plug from the side of the hydraulic reservoir
and install the temperature sensor using thread sealing tape. Run the white wire from the (s)
sensor post of the gauge to the temperature sensor on the hydraulic reservoir tank.
(ASM-C-0051)